Hot Air Generator

Hot air generator specifications are primarily defined by their heat output capacity, the type of fuel used, the resulting maximum temperature, and operational features like efficiency and automation. These factors vary widely between residential and heavy-industrial models. Key Specifications Specification Typical Values/Range Source Heat Output Capacity 10,000 to over 10,000,000 Kcal/hr (approx. 40,000 BTU/hr to millions of BTU/hr) Tradeindia, Suntrack Maximum Temperature Up to 500C for standard units; some high-temp units reach 700C - 1000C Tradeindia, Suntrack Fuel Type Highly versatile: Natural Gas, LPG, Diesel, Furnace Oil, Kerosene, Coal, Wood, Biomass/Agro Waste, or Electricity Tradeindia, Thermtech Thermal Efficiency 80% to over 95% (higher for direct-fired or electric types) Tradeindia, Suntrack Firing Mode Automatic for gas/oil/electric; manual or automatic FBC (Fluidized Bed Combustion) for solid fuels Xtreme Mech, Thermtech Power Supply Typically three-phase (415V, 50 Hz), single-phase available for smaller units Xtreme Mech, Integro Material of Construction Mild Steel (MS) or Stainless Steel (SS 304/316), depending on application and hygiene needs Integro, Heatcon Sensors Design Type Direct-fired (higher efficiency, flue gases enter process) or indirect-fired (clean air, heat exchanger used) Thermtech Safety Interlocks Flame failure device, high temperature alarms, low air pressure switches, and PLC-based controls BS Jagdev & Sons, Thermtech